6
13) SPEAKER OUTS The amp offers the following speaker output jacks for connecting the head to a speaker cabinet or cabinets: one 4 ohm,
one 8 ohm and one 16 ohm jack. Verify the impedance of your speaker/s prior to connection, and make sure you are using the correct speaker
output/s.
14) PRE OUT/AMP IN The DV 403 CPC features an effects loop for use with outboard effect processors or pedals. Connect the PRE OUT
jack to the input of your processor or pedal chain, and connect your effects output to the AMP IN jack.
15) LOOP ASSIGN The Loop Assign knob allows you to assign the effects loop to whichever channel you want, to all the channels, or to none
of the channels. You can make this selection in manual mode (using this knob) or by using the SMART CONTROLLER. When you connect the
Smart Controller to its dedicated input (17), this rotary knob must be set to ENABLE. In this position, the channel switching and solo boost
footswitches are inactive, and all the settings will be managed by the Controller. The Controller automatically recalls the settings you last used
before the amp was powered off. For example, if you assign your effects to channel 2 using the controller, and turn off the amp, the next time
you turn on the amp and plug in the Controller, the effects will still be assigned to channel 2.
16) CH SELECT This switch allows you to switch channels manually when the Smart Controller is not connected to the amp. Pressing this
button advances to the next channel in sequence (1-2-3-1-2-3 etc), and the channel that is active is identified by the indicator LEDs on the
amp’s front panel.
17) CONTROLLER This stereo input jack is exclusively for the Smart Controller. Other footswitches will not work connected to this input.
18) MIDI IN This input port receives incoming MIDI information from an external MIDI device. The MIDI receive address is set to “0” by
default. If your external MIDI device transmits on another address, you can change the default address by holding the CH SELECT (16) switch
for about 10 seconds—the unit then enters “Learn Mode” and you can set the new address by pressing any switch on your MIDI pedalboard
to initialize the connection to the amp.
19) MIDI OUT/THROUGH This output jack sends out MIDI messages identical to those coming in through the MIDI IN.
20) BIAS Switch (low/high) Triple 6 can operate in either Low Bias mode or High Bias mode. When this button is pressed in, the power
tubes work in High Bias mode; when the button is out, they work in Low Bias mode. In Low Bias mode, the tubes use less power and less ‘tube
life’ is taken out of them. High Bias mode gives top quality and power, and higher-fidelity sound—but the power consumption and dissipation
of the tubes increases. In either mode, unlike other tube amplifiers, the Triple 6 is able to greatly prolong the life of its tubes by keeping them
REAR PANEL
(12 pages)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals